NEMETH DESIGNS - SIKORSKY CH-54A & ERIKSON S64E SKYCRANE FSX P3D

SIKORSKY CH-54A & ERIKSON S64E SKYCRANE FSX P3D

NEMETH DESIGNS
EUR 14.50
$
£
¥

The Sikorsky CH-54 Tarhe is a twin-engine heavy-lift helicopter designed by Sikorsky Aircraft for the United States Army. The first flight of the turboshaft-powered Skycrane was in 1962 and the U.S. Army purchased more than a hundred and designated them as CH-54. Used in Vietnam for troop transport with the attachable palletised container and downed-aircraft retrieval with the sling-load system, it was highly successful. The Skycrane can not only hold its cargo up and tight against its center spine to lessen drag and eliminate the pendulum effect when flying forward, it can winch vehicles up and down from a hovering position. After the Heavy Lift Helicopter program was cancelled the Skycranes remained in U.S. National Guard service until the early 1990s.

Today Erickson Air-Crane operates the largest fleet of this helicopter in the world under the name Erickson S-64E Aircrane which can be equipped with water-dropping equipment for firefighting duties. After obtaining the type certificate and manufacturing rights in 1992 Erickson Air-Crane remains the manufacturer and world’s largest operator of S-64s.

This addon represents both the CH-54A Tarhe and the Erickson S-64E Aircrane variants.

  • Accurate and detailed interior and exterior visual models
  • Custom exterior and interior animations
  • HD textures
  • Fully clickable dynamic virtual cockpit with 3D instruments
  • Perfectly flyable from the VC
  • Realistic flight dynamics
  • Two different versions for both variants
  • Working water-dropping system
  • Working sling-load system
  • PDF manual
weiterlesen
KUNDENREZENSIONEN
Ø aus 6 Kundenrezensionen
Eigene Rezension schreiben 
weiterlesen
Sprachfilter:
  • Alle (6)
  • English (4)
  • Deutsch (2)
  • Francais (0)
  • 简体中文 (0)
  • русский (0)
Bewertungsfilter:
  (3)
  (1)
  (1)
  (0)
  (1)
Neueste Kundenrezensionen:
David
*Verifizierter Produkt Benutzer*
18.05.2021
Picked this up on a whim and I’m glad. Real sharp looking both indies and out. No blurry textures on my end. (FSX SE Win10 3.2ghz 16gb RAM Intel UHD 630 integrated graphics) it handles a bit differently than other helicopters as should be expected. Can’t seem to lower the claw so far, but I also just figured out how to raise and lower the firefighting water nozzle so I probably can’t say it’s a problem at all right now.

Its fun to fly around in but obviously too large for a lot of rooftop helipads. I love flying over the Hollywood hills dispensing huge loads of water to drench the hillsides. While the nozzle does go up and down it does not actually do anything like load the tank. The tank is always loaded so there’s some pretending when lowering it to “fill” the tank so to speak. At any rate it’s a nice and very unique helicopter.
Alexander
*Verifizierter Produkt Benutzer*
03.08.2011
Aussenmodelle sehen super aus!
Das VC ist wirklich gut, könnte aber meiner Meinung nach noch etwas deteilreicher sein.
Der Sound klingt zwar recht satt, ist aber leider nicht besonders sauber umgesetzt worden (Sich ständig wiederholende Klicks).
Der Hubschrauber ist sehr kopflastig, keine Ahnung ob das beim Original auch so ist, ist aber halt dadurch schwieriger ihn im Schwebeflug zu halten.
mark
*Verifizierter Produkt Benutzer*
01.10.2010
Damn! This helicopter is the best ive seen yet but it is'nt for the begginer, I have spent hours in this cocpit following the proper startup procedures in the manual and still cant get it to start. $40 dollars is a lot to spend on software if it does not work, It has also been a week and no word back from tech support. buyer be ware!.
Uwe
*Verifizierter Produkt Benutzer*
16.09.2010
Miserabeler Kundenservice ! Preis-Leistungsverhältnis der Ware nicht akzeptabel !
Brandon
*Verifizierter Produkt Benutzer*
04.08.2010
This is one of the best payware add-on helicopters ever! It is very detailed and easy to fly. I was lucky enough to not experience the blurry textures. (Only happens for some users; can easily be fixed with the patch) We have needed a good skycrane for FSX for a long time, and it is finally here!
Charles
*Verifizierter Produkt Benutzer*
13.07.2010
I held off reviewing this as it's my first payware helicopter and I was not entirely happy. Nemeth have produced a patch now and it addresses my issues. WOW! Love to fly it, looks great outside and inside (without the patch they're blurred) now. Very happy with my purchase.
weiterlesen
DATEIGRÖßE
175.94MB
ANFORDERUNGEN

FSX + Acceleration Pack, FSX Steam Edition Prepar3d 4

SPRACHE
English
ENTWICKLER
Nemeth Designs
Kundenrezensionen
NEMETH DESIGNS - SIKORSKY CH-54A & ERIKSON S64E SKYCRANE FSX P3D
Alexander
Aussenmodelle sehen super aus! Das VC ist wirklich gut, könnte aber meiner Meinung nach noch etwas deteilreicher sein. Der Sound klingt zwar recht satt, ist aber leider nicht besonders sauber umgesetzt worden (Sich ständig wiederholende Klicks). Der Hubschrauber ist sehr kopflastig, keine Ahnung ob das beim Original auch so ist, ist aber halt dadurch schwieriger ihn im Schwebeflug zu halten.
NEMETH DESIGNS - SIKORSKY CH-54A & ERIKSON S64E SKYCRANE FSX P3D
Uwe
Miserabeler Kundenservice ! Preis-Leistungs-
verhältnis der Ware nicht akzeptabel !
aufenthaltsland/region
Newsletter - Bleib immer auf dem Laufenden!

The New SIMMARKET App

Explore an endless world !

Download App