Unique re-implementation of the P3D trim system by means of device drivers
Automatic trim system change when using the autopilot
Own trim instrument
Convenient configuration program
No negative impact on the frame rate
RealTrim Professional is a unique new implementation of the standard P3d trimming system. The new implementation is completely independent and runs in parallel with P3D. As in reality, you adjust the pressure on the flight yoke by holding the elevator in its given position while keeping your joystick or flight yoke comfortably in the middle position. The leading air on the trim wing keeps the elevator permanently in its position. You can see this on the flight yoke as well as on the elevator. The flight yoke remains in the trimmed position and cannot be pulled backward or forward over its maximum stop. The trimming process does not take more than three seconds.
HOW DOES IT WORK?
if you turn the trim wheel, neither the elevator nor the flight yoke moves, but the airplane changes its angle of inclination in the direction in which you previously rotated the trim wheel. This can lead to completely unrealistic flight conditions since with a fully upward trimmed airplane, the elevator and the flight yoke is still in the middle position and you could give a full impact in one direction. In reality, you can't do this, of course. RealTrim Professional, on the other hand, works as in reality. The elevator and the flight yoke remain in position after the trim process. This is achieved by installing a virtual driver in conjunction with control software and a matching trim instrument.
With RealTrim professional you can now trim as fast as real pilots are accustomed to.
Requirements
Operating System
Windows 10 (64 bit)
Windows 8 SP2 (64 bit)
Windows 7 SP1, SP2 (64 bit)
Simulator P3DV4 64 bit
RealTrim Professional does not work with Windows Vista or Windows XP